RAT - Jazz
' width='576' height='270'/>

Friction Joint

When unfolded, the Jazz stand is adjusted by raising or lowering it to the desired height and leaving it there. Its friction joints ensure that it stays at the right height.

Strong, rigid and light

The anodized aluminium stem is very strong, rigid and light. This stand doesn’t sway, and yet can be adjusted smoothly and easily.

Virtually unbreakable

The injection moulded tray is virtually unbreakable; if bent, it springs back. The tray is made of a polymer which does not “ring” when knocked. It has smoothly rounded edges all over – safe to handle and kind to your instruments

Additional shelf

The tray has an additional shelf for pencils and small instruments. Friction locks automatically hold the tray at whatever angle you set. There are no knobs to fiddle with or lose, and it will never go slack.

Rubber feet

Diecast aluminium legs with super-tough scratch resistant epoxy coating give enormous strength with low weight. Rubber feet preserve your floor and prevent clatter if the stand is knocked

Fully flexible

The Jazz Stand goes high enough for the trumpeter, yet low enough for the youngest cellist. The Jazz Stand’s reversible legs enable it to be used as a portable conductor’s stand.

 

  • Construction

    Structural parts: Aluminium
    Feet: Rubber
    Tray: Polypropylene
    Coating: Anodised aluminium

  • Dimensions

    Tray width: 503mm
    Tray height: 323mm
    Depth of tray lip: 57mm
    Lowest height to bottom of score: 432mm
    Tallest height to bottom of score: 1207mm
    Nesting pitch: 120mm
    Floor area occupied by 20 stands: 503mm x 435mm x 515mm *10 stands stacked
    Weight: 2.7kg

  • Demonstration Video
Physical Dimensions

H: 40cm - 120cm | Tray: 51cm x 32cm | Wt: 2.8Kg

Contact Form

Message

Thank you. Your enquiry has been sent.

Tweets
    2017 Copyright and all rights reserved by Markson Pianos Ltd